ACTiSYS Corp.
Serial-IR Dongle Installation Manual
Release 1.41
ACTiSYS Corporation 2001 All Rights Reserved
15
WINDOWS 2000 INSTALLATION GUIDE
Note
: If you do not change your computer BIOS setting,
STOP
here and go to
Chapter BIOS SETUP.
Note
: If your computer system has installed some device on the same com
port before, you
MUST
properly uninstall the devices first. ACT-IR210L would
NOT
work with your system any more if the devices are uninstalled improperly
because some drivers are still there and cause conflicts with ACT-IR210L
driver. You
HAVE
to re-install your Windows 2000 again.
Note
: If your computer system has installed a
FIR
device before, ACT-IR210L
would
NOT
work with your system any more. You
HAVE
to re-install your
Windows 2000 again.
Note
: If you want use
Virtual COM Port
in your application,
STOP
here and
change IR210Lto USB-IR Dongle.
Following are the instructions to properly install the ACT-IR210L Dongle. You
need a computer system with a built-in SIR chip and Windows 2000 already
installed. If your motherboard’s IR head is not 5 pins, you have to re-assign
the pins according the definition.
1. Connect ACT-IR210L serial adapter to Desktop PC.
2. Startup your computer system.
3. Click on
Control Panel
.
