Revised
Nov. 3, 2016
Page | 5
Operating Your Action Trackchair
When you are ready to drive the Trackchair, make sure controls are in the off position
before sitting in Trackchair.
When operating your Trackchair, make sure you are securely fastened in with either the lap
belt or 4 point harness.
Your Trackchair can be programmed by your distributor/dealer to have the option of locking
the joystick or not, ask them about the availability for this option
If your Trackchair has a locking control,
it can be unlocked in this way
. Turn control on, hold
joystick forward until you hear a beep or three seconds, then joystick back until you hear a
beep or three seconds. It is now unlocked and ready for operation.
When
locking the control
, (if this option is selected by the distributor/dealer/customer) it is
done in this way. After the control has been turned off, hold the on/off button until the
control has cycled both on and then off. Control is now set in the locked mode.
The Action Trackchair control has five speeds, one-five and can be changed with the up and
down arrows.
Battery indicator is on the main screen on controls. Battery charge will last up to six hours,
depending on battery condition and type of use the Trackchair is subject to. Action
Trackchair has a built-in battery charger that plugs into 110 volt outlet.
Optional lighting is available and is controlled on the joystick control panel.
If your Trackchair has no separate Tilt–On-The-Fly rocker switch, tilting of the chair is
possible by pushing the “M” button on controls, and then moving joy stick forward or
backward to tilt chair. Cancel by pushing “M” again or moving joystick to the left.
If for some reason it is necessary to pull the Trackchair. Disengage the brakes on the motors
with the levers on back of motors. Push levers to the outsides on both motors. Do not pull
Trackchair more than 5 MPH
Action Trackchair does not recommend operating your Trackchair in the salt water,
although our Trackchairs are powder coated to the highest quality with very durable
powder coat, salt water is very corrosive and causes problems with powder coat and metal.
If your Trackchair has been exposed to salt water, rinse the Trackchair completely with fresh
water and dry off.
