7
S002025 Action 4 Unit Swing Set
Assembly Instructions
Prior to assembling this swing set, remove all parts from the carton and check to ensure that all parts
listed in the Parts List and Hardware List (on pages 5 & 6) are present. If you’re missing any of the parts,
please call our National Service Centre to have replacement parts sent out prior to beginning assembly
(details can be found in the warranty pages at the end of this manual).
Note:
It is recommended that 2 adults assemble this swing set.
Step 1
Note:
When assembling the swing set, it is recommended that you only tighten the hardware enough
so that it is finger tight. Once the swing set is completely assembled and moved into the location in
which it will be used, insert the ground pegs and completely tighten the hardware. This will allow the
swing set to adjust to the surface and reduce the "sway" of the unit.
Connect Left Top Bar (1) and Centre Top Bar (9). Place 2 x Top Bar Brackets (51) over the top and bottom
of Left Top Bar (1) and Centre Top Bar (9), secure these into place using 2 x M8 x 62mm Bolts (F1).
Step 2
Connect Right Top Bar (2) and Centre Top Bar (9). Place 2 x Top Bar Brackets (51) over the top and bottom
of Right Top Bar (2) and Centre Top Bar (9), secure these into place using 2 x M8 x 62mm Bolts (F1).
1
9
F1
51
51
F1
2
9
