Actiforce STEELFORCE PRO SLS 270, Инструкция по сборке

Страница: 19 / 72

19
25mm
(1”)
25mm
(1”)
2
5
m
m
(1
”)
3.12 Clearance around the wall or moving parts 25mm of the table
Allow a minimum clearance of 25mm (1“) from the edge of a table top to a wall
or moving parts.
English
UP DOWN
Please make sure that the workstation frame can move freely and correct at all
times.
In case you need to disconnect cables from the electrical components always be
sure to disconnect power first.
In case the height adjustment is not operating normally, stop using the workstation
frame immediately and disconnect the power. Get in contact with customer service
for further advise
3.13 Frame test without table top
Reset Mode
The first time you put in the plug of the power supply into the socket the height adjustment can only
be operated in the reset-mode. As long as the reset-mode is enabled, the system can only move
downward. In order to use the system normally, please follow the next steps:

Press and hold the down-button, the system slowly moves downward.

Please move the system to the lowest position. This position will be used as reference-point (zero-
point).

Keep the button pressed for a moment when the system has reached the lowest position. This
will end the reset-mode.

The system can be operated normally now. Press and hold the up- or down-button to move the
system to the desired height. The system stops when you release the buttons.

15