actiLib Autoloader 1U
– User and Service Guide
Page 87 of 97
2
3
4
5
6
1
6
Figure 453 Drive sled components of rear panel
Steps
Description
1
Power down the loader using the power button on the front pan.
2
The LED on the tape drive being removed is off.
3, 4, 5
Remove the power cable, SCSI cable and terminator if applicable, from the tape
drive being remowed.
6
Loosen the captive thumbscrews on the drive
Table 14 Description for Figure 45
IMPORTANT
Before pulling the drive sled out, please pull forward the
product ID tag located below the drive sled (see figure 53
detail 1). Otherwise the slide or the attached label could
be damaged.
2.
Pull straight back on the tape drive handle to remove it from the loader. Take care to slightly
push down the product ID slide so it does not interfere with the drive sled (see
).
1
2
3
Figure 464 Tape drive removal
