actiLib Autoloader 1U
– User and Service Guide
Page 24 of 97
6.9
Rack mounting the tape loader
The loader easily installs into a standard 19” rack system taking up 1U of space.
The actiLib tape loader weighs 13.1 kg (29 lbs) with 8 cartridges
WARNING
Weight!
Risk of personal injury or damage to the loader.
always remove all tapes to reduce the overall
weight of the loader
observe local health and safety requirements
and guidelines for manual material handling
Required tools:
#3 Phillips screwdriver
T10 Torx screwdriver
There are two sets of eight M6 screws in the accessory package that came with your loader.
The type of rack that you have will determine the type of M6 screw that you will use.
To install the loader:
1.
Determine the location in your rack for your loader to be installed and, using a pencil, mark
the location on each vertical rail in your rack.
2.
Using the appropriate M6 screws for your rack type, and a #3 Phillips screwdriver, secure
one rail to each side of the rack in your chosen rack location. Secure both the front and
back of each rail to the rack. The rails extend to fit a variety of rack depths. The correct
orientation of the left and right rails is shown in Figure .
Figure 10 Installing the rails into the rack
