www.acti.com
Hardware Manual
6
Safety and Compliance Information
Installation and removal of the unit and its accessories must be carried out by qualified
personnel. You must read all of the Safety Instructions supplied with your equipment before
installation and operation.
Installation
This device is a class A product and may cause radio interference. Take measures if
necessary.
Make sure the camera operates in an environment where the temperature and humidity
meet requirements. Keep the camera from excessive pressure, vibration, moisture, dust,
and intensive electromagnetic radiation.
Use a power adapter or a PoE device that meets requirements. Otherwise, the device may
be damaged.
Make sure the length of the power cable between the power adapter and the camera is not
too long, otherwise the voltage of the camera is lowered, causing the camera to work
abnormally. If it is required to lengthen the power cable, lengthen the cable between the
power adapter and the mains.
Do not hold the tail cable by hand for weight bearing. Otherwise, the cable connector of the
camera could be loosened.
Do not cut the tail cable. Exposed tail cables may cause short circuit and damage the
camera.
When connecting to an external interface, use an existing connection terminal, and ensure
that the cable terminal (latch or clamp) is in good condition and properly fastened. Ensure
that the cable is not tense during mounting, with a proper margin reserved to avoid poor
port contact or loosening caused by shock or shake.
The end of the tail cable must be kept under good protection. Take waterproof measures to
protect the tail cable.
During the process of transportation, special attention is required for the protection of the
transparent dome cover to prevent friction, scratch and contamination, etc. In order to
keep the cover clean, do not remove the protective film on the cover during mounting. After
mounting is finished, remove the film before the device is powered on.
Contact professionals for maintenance information. Do not attempt to dismantle the device
by yourself. We shall not assume any responsibility for problems caused by unauthorized
repair or maintenance.
