www.acti.com
Hardware Manual
11
Installation Procedures
This section describes procedures in mounting the camera on a flat surface.
NOTE:
The camera images on this documentation are for reference only and may be different
from the actual camera.
Before Installation
Make sure the device in the package is in good condition and all the assembly parts are
included.
The standard power supply is 12 VDC or PoE (802.3af).
Please make sure your power supply matches with your camera.
Make sure all the related devices are powered off during the installation.
Check the specification of the products for the installation environment.
Make sure that the wall is strong enough to withstand four times the weight of the camera
and the bracket.
Dust or grease on the camera cover will cause IR reflection.
Please DO NOT remove the camera cover film until the installation is finished. If there is
dust or grease on the camera cover, clean the camera cover with clean soft cloth and
isopropyl alcohol.
Make sure that there is no reflective surface too close to the camera lens. The IR light
from the camera may reflect back into the lens causing reflection.
DO NOT drag the camera with its waterproof cables, or the waterproof performance is
affected.
