www.acti.com
Hardware Manual
9
Installing the Camera
The intercom camera is designed to be directly flush mounted on the wall. The front panel is
visible and will be aligned on the surface of the wall. This installation requires access to the
back of the surface.
Step 1: Prepare for Installation
1.
Attach the bundled drill template sticker on the target installation surface.
2.
Drill the hole where the camera body will be mounted. Note that the connectors are on the
bottom side of the camera; make sure that side can be accessed from the back of the
surface.
3.
Drill the screw holes, as needed.
4.
Remove the drill template.
Step 2: Mount the Camera
1.
Mount the camera body through the hole.
2.
Attach the four (4) screws to secure the camera on the surface.
NOTE:
The device front panel is waterproof. However, you must ensure to seal and
protect water from entering through any gap on the surface wall which may flow to the
cable connections on the bottom of the camera.
Step 3: Connect the Camera
1.
Connect the other end of the network cable from the camera to the network. Connect all
other devices, if any.
2.
Connect the other end to a switch or injector. Then, connect the switch or injector to a
network or PC and a power source. See Power-over-Ethernet (PoE) example connection
diagram below.
Network
AC Power
Source
PoE Injector /
PoE Switch
Power Cable
Ethernet Cable
Ethernet Cable
(Data + Power)
Ethernet Cable
(Data)
Camera
