www.acti.com
Hardware Manual
28
Other Connections
This section describes the procedures in preparing the external devices that you can connect to
the camera. The camera supports DC12V power input, Digital Input and Output (DI/DO) and
Audio Input and Output devices. The use of these devices, however, is optional.
NOTE:
If these connectors will not be used, leave the covers on and adapt a suitable
waterproofing method to ensure cables remain protected from water and eliminate short-circuit
hazards.
Connecting a Power Adapter (Optional)
In case of using a non-PoE switch or your PoE switch has limited power supply, you can
purchase a power adapter and directly connect the camera to a power outlet. The power adapter
must be connected to the supplied terminal block before use.
To do this, follow the procedures below:
1.
Loosen the screws of the
12V
and
GND
pins of the power terminal block.
Digital Input / Output
Audio Output
Audio Input
Power Connector
