Check
Power
Reflection
Frequency
Waterfall
With “Check” you can test the base station. If it
fails the test, arrows will point to the specific
measurements that indicate the failure. You can
then enter comments on the result or save the
result as a screenshot.
Press this button to check the output power
alignment, including ripple detection. Power is
measured in actual values (dBm).
This application is used for measuring the signal
reflection.
If you want to measure the frequency spectrum,
press this button; the application also provides to
check against a template.
The Waterfall application gives you a general
overview over the RF environment. Interference
in the selected frequency band is detected and
displayed.
