Loading application module software upgrades
June 2004
FST-2000 TestPad Service Pack/Upgrade/Optioning Instructions
3
5
Turn the TestPad power ON.
A series of boot-up screens appear as the TestPad powers on,
loads the service pack, and then automatically reboots.
When the main screen appears, the service pack is loaded.
Loading application module software upgrades
The following procedure describes how to load an application module
software upgrade. Loading a software upgrade can take up to one
hour.
To load an application module software upgrade
1
Make sure the application module is properly connected to the
UIM.
2
Make sure the TestPad is OFF.
3
Connect the AC adaptor that shipped with your UIM to the
TestPad, and then plug the adaptor into a power source.
4
Do one of the following:
– Insert the PCMCIA card with the software upgrade into one of
the PCMCIA card slots located on the unit’s top panel.
– If you previously downloaded the software upgrade on to the
TestPad, you do not need to insert a PCMCIA card. Proceed to
.
5
Turn the TestPad power ON.
A series of boot-up screens appear as the TestPad powers on,
followed by a dialog box informing you that a newer version of
software has been detected for the application module. The dialog
box prompts you to upgrade the software.
6
Respond to the prompts as directed.
After all upgrade files are loaded, the TestPad automatically
reboots, and the main screen appears.
The application module software upgrade is loaded.