ACTpro MIFARE classic Operating and Installation Manual
Rev 1.0
Reader Configuration
Operation: ACTpro MIFARE 1030PM / 1040 / 1050
The ACTpro MIFARE readers can operate as a sector, serial or reverse serial reader. The operation of the ACTpro
MIFARE classic 1030PM, 1040 and 1050 is selectable via a jumper. The default position of the jumper is set for
sector operation (jumper on pins 1 and 2). To change the operation down power the reader, change the jumper for
the desired operation and reapply power.
Sector
Serial
Reverse Serial
Connect pins 1&2
Connect pins 2&3
Do NOT connect Jumper
Sector / Serial
Operation Jumper
Operation: ACTpro MIFARE 1030
The operation of the ACTpro MIFARE classic 1030 is selectable via cable configuration, the default setting is Sector
where both Orange and Purple cables are connected to 0V. To change the operation down power the reader,
change the Orange and Purple cable for the desired operation and reapply power.
Colour Sector
Serial
Reverse
Serial
Orange 0V
0V
Not
Connected
Purple 0V
Not
Connected
0V
Sector Reader
The default sector reader operation of ACTpro MIFARE readers is to read the batch numbers that are encoded into
Sector 1 from the MIFARE cards and fobs issued by ACT. However the readers can be programmed to read any
specified sector data, this allows the readers to be installed on sites that are already using MIFARE cards. See
section on reader re-programming.
Serial and Reverse serial Reader
When in Serial or reverse serial mode the MIFARE card serial number is read by the reader.
5
