read correctly, and by the way to test the reading speed.
2-2-5 Disk Info
：
Function 5 Disk Info is to show the basic information of
source HDD.
2-2-6 Select Source
：
Function 6 select source is to let you select which HDD as
the source from which copying will be done. For example,
before you execute copying between IDE HDD and SCSI
HDD, you have to check which one is your source HDD to
avoid your source HDD damage. If your source and target
HDD are SCSI interface, remember to set the source ID as
0 and set the target ID as 1 on the SCSI HDD.
2-2-7 Setup
：
Function 7 Setup lets you change the default settings.
2-2-8 Adv-setup
：
Function 8 Adv-setup lets you change the system
configuration.
3
．
General Functions
3-1 Prescan
：
Before copying or fail copying, you can use this function
to scan if the source HDD can be read correctly, and test
the reading speed.
3-2 Read Error Skip
：
If 8-01 Read Error Skip is to neglect any error that occurs
during copying. Under normal circumstances, when an
error occurs during copying, a message will appear LCD.
3-3 DMA mode
：
Function7-02 DMA mode is depending on quality of your
IDE HDD to set transferring rate of this HDD copying.
If your source HDD is IDE or SATA HDD, but target is
SCSI; when you execute copying HDD, only one thing
you have to pay attention is to make sure DMA mode is
setting on transferring rate of UDMA0!!
