Acson international ACC 10 C/CR, Руководство пользователя

Страница: 61 / 78

60
Warning
Disconnect from Main Supply before Servicing the air conditioner
The unit is designed to give a long life operation with minimum maintenance required. However, it should be
regularly checked and the following items should be given due attention.
Components Maintenance Procedure Recommended Schedule
Air Filters 1. Clean with a vacuum cleaner, or by tapping lightly
and then washing in lukewarm water (below 40°C)
With neutral soap.
2. Rinse well to dry before re-installing.
3. Note : Never use petrol, thinner, benzene or any
other chemicals.
Every 2 weeks.
More frequently if required.
Indoor Unit 1. Clean away dirt or dust on grille or panel by wiping
with a soft cloth soaked in lukewarm (or cold)
water or neutral detergent solution.
2. Note: Never use petrol, thinner, benzene or any
other volatile chemicals, which may cause
plastic surface to deform.
Every 2 weeks.
More frequently if required.
Condensate Drain
Pan & Pipe
1. Check and clean. Every 3 months.
Indoor Fan 1. Check for unusual noise. As necessary.
Indoor/Outdoor Coil 1. Check and remove dirt which are clogged between
fins.
2. Check and remove obstacles which hinder air flow
in and out of indoor/outdoor unit.
Every month.
Every month.
Electrical 1. Check voltage, current and wiring.
2. Check faulty contacts caused by loose connections,
foreign matters, etc.
Every 2 months.
Every 2 months.
Compressor 1. No maintenance needed if refrigerant circuit
remains sealed. However, check for refrigerant leak
at joints & fittings.
Every 6 months.
Compressor
Lubrication 1. Oil is factory charged. Not necessary to add oil if
circuit remains sealed.
No maintenance required.
Fan Motors
Lubrication 1. All motors pre-lubricated and sealed at factory. No maintenance required.
PRE-START UP MAINTENANCE (AFTER EXTENDED SHUTDOWN)
-
Inspect thoroughly and clean indoor and outdoor units.
- Clean or replace air filters.
- Clean condensate drain line.
- Clean clogged indoor and outdoor coils.
-
Check fan imbalance before operation.
-
Tighten all wiring connections and panels.
-
Check for refrigerant leakage.
13. SERVICING AND MAINTENANCE