DOCUMENT NUMBER: OPMM-001E-R0
Proprietary Information:
This document is the property of ADVANCED CONTAINMENT SYSTEMS, Inc. It shall not be copied
or duplicated and shall not be submitted to outside parties without the company consent.
Page 4 of
8
8/21/2017
Fig. 1 Control Panel
3.3
Control Panel:
3.3.1
High-Off-Low Switch to start and select the speed of the unit
3.3.2
Push Button Breaker 20 Amp
3.3.3
Power Supply (PS) Receptacle 15 Amp
3.3.4
Pressure Gauge
3.3.5
Sensing Port
3.4
Turning unit
On
:
3.4.1
The switch must be in off position, before connecting the power supply.
3.4.2
The main switch is located on the control panel (see fig. 1) and is a three position
switch (High-Off-Low). Push the switch to the right to operate in low speed or to the
left to operate in high speed, the middle position is off.
3.5
Turning unit
Off
:
3.5.1
To turn the unit off, set the switch to the middle position.
3.5.2
At the end of the project, the filters should not be removed, instead the intake
opening should be sealed with polyethylene film and duct tape.
High-Off-Low Switch
Breaker 20 Amp
Pressure Gauge
PS Receptacle
Sensing Port
