ACS 3200 Series, Руководство по эксплуатации и инструкция

Страница: 18 / 56

3200 Series Granulators 63”and 84” 357563 • 08/22/2019 18
3-4 Accessing the Cutting Chamber
You will need to access the cutting chamber before initial startup and for various
maintenance procedures. Before accessing the cutting chamber, make sure no one is near
the hydraulic cylinders or hopper. The hydraulic cylinders should not operate until the rotor
is completely stopped. If the hydraulic system does operate while the rotor is still turning,
immediately shut down the machine and call for maintenance to adjust it.
Use the following procedure to access the cutting chamber:
1. Turn the main power off, remove the line fuses, and tag the machine as out of
service.
2. Unscrew the cutting chamber interlock actuator screw with a box wrench or
ratchet wrench. Make sure the end of the interlock actuator screw is visible and
clear of any contact. When disengaged, the interlock opens the electrical control
circuit to the motor and prevents the machine from running.
3. Turn the cutting chamber hold-down fasteners counterclockwise to remove
them, and place them on the lip of the upper cutting chamber. There are
fasteners on the front and rear of the granulator.
4. Start the cutting chamber hydraulic cylinders from the open/close control panel
by turning the CC/Hopper switch to the “Raise” position and pressing the button
in the center of the switch. Hold the button until the hopper stops, and then
release the button and return the switch to the off position.
5. Position the rotor so that a blade is at the top center, pivot the cover plate to
the open position, and turn the rotor locking nut until it extends into the guard
through the opening provided. Tighten it against the rotor flywheel to keep the
rotor from turning.