Acrel Co.,Ltd
Address: No.253 Yulv Road, Jiading district,Shanghai,China
Tel: 021-69156352 E-mail: [email protected]
Calibration Guide
AMC16-DETT
I communication connection
1. As shown in Figure 1, first select the correct port, then select the correct
baud rate (default 9600) and address according to the wiring diagram
identification printed on the meter side, at last click “open the serial port”.
Figure 1
If Figure 2 pop-up, you need to check whether the selected port exists or is
occupied.
Figure 2
2. Click communication, observe until the times of sending and receiving are
equal (like Figure 3), which indicating that the communication between PC and
meter is normal. Other parameters can be modified at this time.
Figure 3
II
Modify address
As shown in Figure 4, when the meter communicates normally, input the
address to be set in the text box on the right side of "set address", then click
"set address" to set the parameters.
Figure 4
When the dialog box as shown in Figure 5 pops up, the setting is successful.
