Acquisitions BLOOMSBURY, Инструкция по установке, эксплуатации и обслуживанию

Страница: 2 / 28

Page 2
AB-G200L-REM-I01-150914
INSTALLATION INSTRUCTIONS
CONTENTS
Important Notes
Page 2 Commissioning the Stove Page 8
Technical Information Page 3 Check for Spillage Page 8
Dimensions and Clearances Page 4 Customer Briefing Page 9
Installation Page 5
IMPORTANT NOTES

This stove is a fuel effect radiant convector. Before installation, ensure that the
local distribution condition (identification of the type of gas and pressure) and the
adjustment of the appliance are compatible. The data label is located at the rear of
the stove. The installation must be in accordance with these Instructions and
National Regulations and must be carried out by a qualified installer.

Any flue damper plate or flue restrictor must be removed or fixed permanently in
the fully open position, or shall only be fitted in accordance with National
Regulations.

If the chimney has previously been used to burn solid fuel, the chimney should be
swept before the stove is installed.

Before the stove is installed a flue test in accordance with National Regulations
should be carried out. The gas connection must be in accordance with National
Regulations.

The stove is fitted with a spillage monitoring system consisting of a thermal switch
connected to a thermocouple interrupter. This system is not adjustable, and must
not be put out of action. If any parts of the spillage monitoring system require
replacement only original manufacturers’ parts must be used.

All surfaces except the control unit are considered to be working surfaces.

The stove should not be used for any other purpose than as a room heater and a
decorative stove.