ACP MRX2SW, Руководство по обслуживанию

Страница: 25 / 29

ERROR CODES
Code Description Corrective Action
A2 Invalid Display Firmware Update Firmware or Replace Touch Control
B1 Touch Screen Error Replace Touch Control
B2 Wifi Error
Reset Touch Control. If continued failure Replace
Touch Control
B3 Wifi Error
Reset Touch Control. If continued failure Replace
Touch Control
D0 Convect Temp Sensor (RTD)-Open Replace Temp Sensor (Top Left of Oven)
D1 Convect Temp Sensor (RTD)-Shorted Replace Temp Sensor (Top Left Oven)
G0 Oven Exceeded Max. or Min. Temperature
After oven cools, press the cavity thermal cutout’s
reset button found on the bottom, back right hand
corner of oven. If unable to reset, Replace the Cavity
Thermal Cutout. NOTE: Cutout may trip if subjected to
sub-freezing temperatures
G2
Open Magnetron TCO
Board Senses an Open Magnetron TCO. Inspect Cooling
Fans Operation and Airflow, TCO’s and Wiring.
H0 Zero Cross Failure
No or Intermittent Voltage at J1 Connector on Main
Control Board.
H2 Invalid System State Main Control Board
H3 Invalid EEPROM/FLASH Main Control Board
I1
Current Sense-No/Low Amps from Microwave
Circuit
Perform Service Test (Magnetron #1 & #2)
Suspect Door Switches not fully activated or weak door
hinges. Secondary/Monitor Switch assembly is
adjustable.
V0 Low Voltage <188vac Detected by the Main Control Board
V1 High Voltage >263vac Detected by the Main Control Board
Important Note: Error Code History cannot be cleared. Oldest codes will automatically be deleted when
the history log is full.
23