www.acousticamplification.com
5
B300C, B600C
B300C FRONT PANEL
1.
Mute: Mutes the input signal when pressed.
2.
Bass Input: 1/4” two-conductor jack.
Note: Turn the volume all the way down before plugging in your guitar and adjust the volume according to your taste.
3.
Pad: Activates -10dB pad to reduce input sensitivity for basses with active electronics or high output pickups.
4.
Gain: Adjusts the input level signal gain of the amplifier.
Note: Clip indicator lights up when too much gain creates preamp clipping (usually undesirable)
5.
Acoustic-comp™: Activates the built-in compression circuit. Light indicates compressor is active.
Note: Comp light only operates to indicate compressor is actively compressing the signal
6.
On/Off Switch: Activates the Overdrive circuit.
7.
Overdrive: Controls the amount of overdrive when overdrive switch (#6) is engaged.
8.
Overdrive Level: Adjusts the balance between the clean and overdrive channels when overdrive switch (#6) is engaged.
9
. Super-lo: activates low frequency boost (+3dB at 40Hz).
10.
Equalization (knobs labeled Low, Low Mid, Mid, High Mid and High): 5 Bands of adjustable EQ.
11.
Super-hi: activates high frequency boost (+2dB at 7kHz).
12.
Notch Enable: activates the adjustable notch filter (#13).
13.
Frequency Notch: Adjusts the notch filter frequency from 50Hz (left) to 1kHz (right) when notch enable (#12) is engaged.
14.
Volume: Adjusts overall (master) volume level of the amplifier.
15.
Aux In: This 3-conductor 1/8” media input jack will allow you to plug in any audio source with an 1/8” output jack for
practice or to play along to. To control the volume of the source, adjust the output volume from the playback device.
16.
Headphone: 1/8” 3-conductor output jack for plugging in headphones. When used, it will mute the internal speaker
enabling silent play and practice.
16
2
4
7
8
10
13
14
3
1
5
6
9
11
12
15
Содержание B300C
Страница 12: ......
