CONTROL AND OPERATION
NORMAL DISC PLAY
Before playing a disc, check the CD player's power cord and output cable
connections (refer to the section CONNECTING THE COMPACT DISC
PLAYER).
1. Switch on the amplifier and set its input selector to the correct position
for the CD player, or plug the headphones into the headphones socket.
Adjust the headphones volume control to minimum.
2. Press the POWER switch.
3. Press the OPEN/CLOSE button to open the disc tray, and load a disc.
4. Press the OPEN/CLOSE button again to close the disc tray.
5. Press the PLAY button. Disc play will start from the beginning of the
This section describes the compact disc player's controls in the order in
which you would normally use them. Follow the instructions step-by-step
and in a very short time you will master complete operation of the unit.
If the disc is correctly loaded, the following information will be displayed.
EXAMPLE:
There are 8 tracks on the disc.
The disc has a total playing time of 48 minutes and 54 seconds. The CD
player will be set to the standby mode.
NOTES:
• After the disc tray is fully closed, "NO" may be displayed. This means
that the disc is improperly loaded (most likely upside down). To check,
open the disc tray again and reload the disc correctly.
• If the disc tray is blocked while closing, the tray will stop and open
automatically after a few seconds. If this happens, check the disc tray.
Remove any obstacle before closing the tray again.
first track. If the desired track has been selected by
or
button
before pressing the PLAY button, disc play will start with the selected
track when the PLAY button is pressed. Adjust the headphones volume
control to a desired listening level when using the headphones.
6. When the last track has finished playing, the CD player will return to
the standby mode.
NOTES:
If a disc is seriously scratched, or too dirty, disc play may not start.
If an improperly centered disc is played, noise can be heard in the
mechanism. The use of such discs should be avoided.
NORMAL OPERATION
When switching on the power, the TRACK display will show "_ _" for 5
seconds
If there is a disc, the display will show the total number of tracks and total
playing time.
If there is no disc, the display will show " no "
7
