Acoustic Signature TA-2000, Инструкция по эксплуатации

Страница: 6 / 8

6.1 Adjusting the cartridge
Use the plastic (showed in the left picture ) piece and place on top
of the 2 metall pillars facing the Alu center pin downwards. Move
the arm forward or backward so the center pin is exactly fitting into
the small drilled marking on top of the arm. tighten the arm if this
position is exaclty matching. This ensures your template is in the
correct angle for adjusting the cartridge and the distance of the
arm related to the middle of the platter is correct.
... ........................ ....................................
6.2 Adjusting the cartridge
Make sure to use it in the exact orientation as shown in the pic.
This ensures your template is in the correct angle for adjusting the
cartridge.The front Pin of the Alu part needs to be exactly in the
center hole of the tonearm.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.3 Adjusting the cartridge
Lift down the cartridge and place the diamond tip of the cartridge
on the reference point of the alignment gauge and make sure that
the edges of the cartridge are absolutely parallel to the marking
lines printed on the cartridge alignment gauge. For that adjust-
ment it is necessary to take a look directly from the top on the
tonearm and the alignment gauge. We suggest to align only to the
inner point of the alignment gauge!
adjustment plastic with
Alu center pin.
6.4 Adjusting the cartridge
Please make also sure that the leading edge of the cartridge is
parallel to the marker lines of the cartridge alignment gauge and
the needle is exactly in the reference point. If not correct it by
moving forward and backward and changing the angle.
Fix the right position through looking the screw on the top.
OK Not OK