CARTRIDGES
Instruction Manual
Mounting the MM cartridge
Remove stylus unit with stylus guard before
working with leads and screws. Handle all
parts carefully. (fig. 1-2)
Note colours and channel indications on
rear side of the body for correct connection
of the tone arm leads. (fig. 3)
The packing contains a pair of screws with a
thread length of 5 mm. The screws are to be
used with headshell thicknesses of max.
3.5 mm. The MM threaded mounting plate
has a thickness of 3 mm.
To check that you are using the right length
of screws – please observe that screws
must not touch the body under the mounting
plate – look into the small openings on each
side of the body. (fig. 4)
Do not tighten screws completely before the
stylus unit has been remounted (fig. 1) – to
adjust stylus overhang refer to the record
player or tone arm manual and cartridge di-
mensions. (fig. 5)
Never overtighten screws and never use
aluminium screws, as they can get stuck in
the threaded holes of the mounting plate.
Note: If excessively long screws are used
and are pressing against the body material,
this may influence channel separation and
could damage the cartridge body. In case of
such damage the warranty will be void.
