NO SOUND
- Ensure the speaker is charged and with enough power for
operation
- Ensure the speaker is ON.
- Ensure BT device is ON.
- The volume of speaker is too low, adjust the volume to an
appropriate level.
- Unable to connect with Bluetooth device, RESET the speaker
by pressing and holding the Pair/Battery Check button for
12 seconds.
WARNING: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
Note: Clean the speaker with soft, lint - free, dry cloth. Never
use detergents or abrasive cleaners to clean.
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference and
(2)this device must accept any interference received, including
interference that may cause undesired operation.
Important: Changes or modifications to this product not authorized
and could void the FCC compliance and negate your authority to
operate the product.
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
K. TROUBLE SHOOTING
L. FCC COMPLIANCE STATEMENT
7
8
