Acomdata External HARD DRIVE USB 2.0, Руководство пользователя

Страница: 33 / 109

1. If the screws and nuts are not already affixed to the stand,
insert the two screws through the two holes from the
underside of the stand. Screw a nut onto the end of each
screw just far enough to hold the nut to the screw. Do not
tighten the nuts.
. With both screws and nuts in place, push down on each
screw head to make sure the screws extend through the
holes as far as they will go.
. Attach the stand to the Drive case by sliding the nuts
through the groove in the Drive case, entering from the
backside of the case. You cannot slide the stand in from
the front of the case. The stand is symmetrical so it does
not matter which end you insert first. Once the nuts are in
the groove,
position the
stand so that
it is centered
with the Drive
case.
. While holding the stand in place with one hand, use a
screwdriver with the proper type and size head to tighten
the screws. Make sure the stand is firmly secured to the
Drive case.