Acom 1500, Руководство пользователя, Страница: 8 / 25

8
2. INSTALLATION
2 -1. Unpacking and Initial Inspection
N O T E
Before you start to install the amplifier, thoroughly read this manual.
First, carefully inspect the cardboard carton and its contents for physical
damage. If damage is noticed, notify your dealer immediately. Delay may
infringe carrier's warranty conditions. Keep all packing for possible future
transportation!
2-2. Line Voltage Selection
C A U T I O N
To avoid damage (not covered under warranty), check carefully if the
voltage for which the amplifier is set corresponds to your mains nominal
voltage.
Normally the amplifier is supplied set for a nominal line voltage of 240V. If your line voltage
is not 240 V, you must contact your dealer for instructions on how to change the voltage
selector inside the amplifier. The only exception to this is if the unit has been custom
ordered, in which case the voltage selection will be noted in the Table of Individual Data
(Table 2-1, below).
Voltage Selector
Tube s/n
VAC
AMP s/n
Table 2-1. ACOM 1500 Individual Data
C A U T I O N
The current consumed by the amplifier from the line (mains) supply
should not exceed 16A from 200/240VAC and 20A from 100/120VAC.
Therefore you will have to reduce the output power to about 1000W PEP in
case of operation at 120V or lower line (mains) supply voltage.
2-3. Amplifier Location Selection
C A U T I O N
The weight of the unit is about 26.5 kg, which should preferably be
handled by two persons.
Position the amplifier near the place where it will be used. You'll need an easy access to the
command knobs and indicator's area, as well as to the rear panel cabling.