User's Manual | ACOM 1010 | HF Linear Amplifier
July 2021
S e c t i o n SPECIFICATIONS | Page 33 of 40
6.
SPECIFICATIONS
6.1.
Parameters
a)
Frequency Coverage
•
All amateur bands in the 1.8-29.7 MHz frequency range;
•
Extensions and/or changes on request;
b)
Power Output
•
700 W PEP or 500 W continuous carrier;
c)
Intermodulation Distortion
•
Better than 35 dB below rated output;
d)
Hum and Noise
•
Better than 40 dB below rated output;
e)
Harmonic Output Suppression
•
Better than 50 dB below rated output;
f)
Input and Output Impedance
•
Nominal value: 50 Ohm unbalanced, UHF (SO-239) type connectors;
•
Input circuit: broadband, SWR less than 1.3:1, 1.8-30 MHz continuously (no tuning, no
switching);
•
Bypass path: SWR less than 1.1:1, 1.8-30 MHz continuously, 200 W maximum;
•
Output (antenna) impedance matching capability: SWR up to 3:1 or higher;
g)
RF Gain
•
11 dB typically, frequency response less than 1 dB (50-70 W drive power for rated
output);
h)
Mains Power Supply Voltage
•
85-132 VAC / 170-264 VAC (100, 110, 120, 200, 210, 220, 230 & 240 V nominal taps,
+10% -15% tolerance), 50-60 Hz, Single phase;
i)
Mains Power Consumption
•
1200 VA at rated output;
j)
Safety and Electromagnetic Compatibility
•
Complies with CE safety and electromagnetic compatibility requirements, as well as with
the US Federal Communications Commission (FCC) regulations;
k)
Size & Weight (operating, excluding connected cables)
•
WxDxH: 402x315x166 mm, 17 kg (15.9x12.4x6.6 inches, 37.5 lbs.);