SINGLE
VIDEO
PANEL CONNECTION DIAGRAM
OPERATION
When in standby, the display shows the “Intro” message (which reads “
aco
” by default). The “Intro”
message contents are freely configurable. The default range of dialled numbers is 1 to 255, with each
value mapped directly to the physical addresses configured in the inside units (the software
configuration tool permits any dialled number range between 0 and 999999 and a free assignment of
each number to the inside unit address, or to restrict the range of supported inside units). Dialling is
done by inputting the apartment number with the keypad; if the optional 230E module is installed, select
the apartment number entry with the arrow buttons, followed pressing the Doorbell button. After approx.
3 s the receiver in the selected apartment will start ringing. If the dialled call is received in the dialling
mode, a voice conversation is possible with unlocking the door electric strike. Opening the door electric
strike by inputting an apartment code: input the apartment number, confirm with the Key button and
follow with the 4-digit apartment code mapped to the input apartment number.
In order to print the full
table of user codes or ready business cards for tenants together with the instructions for use, use the
"ACO Code Generator" available at
in the user area ("download"). For each "Master"
control panel, the code table is factory-set on the back of the device as a 4-digit number, and for "Slave"
devices, enter the same table as in "Master". Opening the door electric strike with one of the five
building administrator access codes: press the Key button and follow by inputting the six-digit code.
The building administrator access codes are intended for use by building administration and
maintenance personnel, e.g. maintenance technicians, the janitor, postmen, etc. The wired door
electric strike can also be unlocked by shorting the additional
INPUT
to ground. If a proximity reader
(ACC) is wired, the door electric strike is unlocked with the proximity card or keyfob (paired with the
DES and issued to e.g. the tenants, the building administration staff, or the DES installer). An attempt
of entry with a proximity card or keyfob which has not been paired will make the device respond with
three beeps from the speaker. When the door electric strike is unlocked, the display shows the following
