ACME zoopa 300, Инструкция по эксплуатации

Страница: 12 / 22

zoopa 300
12
ENGLISH
Trimming/Adjust
If the helicopter turns around its own shaft after the start, you can adjust it by turning
the trimming wheel on the right top of the controller to stabilize the fl ight attitude.
Technical data zoopa 300
Total length: 392 mm
Total width: 72 mm
Total height: 190 mm
Gyrosystem: integrated
Controller: 2.4 GHz
Receiver: RX-2405 (built-in)
Motor: 2 x 130, 1 x 60
Rotor diameter: 340 mm
Tail rotor diameter: 70 mm
Total weight: 200 g
FAQ
Error Reason Solution
The helicopter does not react to
controller
Controller batteries are not inserted
correctly
Check batteries
Controller batteries are empty Replace batteries
Move gas stick First pull it up, then down and up again
Controller batteries are too weak Replace controller battery
The helicopter does not take height Battery is weak Charge helicopter
Battery is not fully charged Replace controller battery
The range is insuffi cient Controller batteries too weak Replace controller battery
!
Please replace damaged rotors immediately – pay attention to the main rotors’ label! A main rotor above, and B main rotor below –
never install them interchanged!
Camera