Frost
- Frost home position adjustment
Enter offset mode, select
Frost
, press the
ENTER
button to confirm. Use the
UP/DOWN
button to
offset the value from
0
to
255
, press the
ENTER
button to store. Press the
MENU
button to exit.
Focus -
Focus home position adjustment
Enter offset mode, select
Focus
, press the
ENTER
button to confirm. Use the
UP/DOWN
button to
offset the value from
-128
to
127
, press the
ENTER
button to store. Press the
MENU
button to exit.
5.3 Error Information
Lamp Startup Fail
It appears when there is no lamp or some wires are damaged.
Temperature Sense Error
It appears when temperature check board is damaged.
Lamp Too Hot Power Off
It appears when temperature is detected higher than 110
℃
. Check if the unit is properly ventilated,
or fans or temperature check board may is damaged.
Lamp Too Hot Low Power
It appears when temperature is detected higher than 105
℃
, the unit will run on a low power level.
Maintenance Fixture
It appears when the maintenance remaining time becomes 0S, please enter menu mode and reset
the time.
Lamp On Over 700 Hour
It appears when the lamp has been on over 700 hours, please turn off the lamp.
Memory Initial Fail
It appears when the memory IC is damaged.
CPU-B Error, CPU-C Error, CPU-D Error
They appear when board P.C or some wires are damaged.
Pan Reset Error, Pan Encode Error, Tilt Reset Error, Tilt Encode Error, Shutter Reset Fail, Dimmer
17
