3E
A. GENERAL INSTRUCTIONS
Please read the enclosed instructions carefully as they include important points about
safety for the installation, usage and maintenance of the unit.
•
Please keep this booklet with the unit for future consultation. If you sell the unit to
another user, be sure that the new user also receives this instruction booklet thus
giving them the necessary information about the use and general warnings
regarding the unit.
•
Before the initial start-up, please unpack and carefully check all components in
case any damage may have occurred during transportation.
•
Locate in a suitable spot for your device where there is good ventilation. Also, make
sure that no ventilating fans or slots are blocked.
•
Protect our environment! Please dispose of the packing boxes properly.
•
The electrical work that is necessary for installation must be done by qualified
personnel.
•
Always remember to unplug the unit from the main power before any service is
done. Do not open the unit. There are no serviceable parts inside.
•
It is very important to ground the yellow/green conductor to earth in order to meet
regulations for safety.
•
Check the surrounding area and make sure there are no flammable liquids, water or
metal objects that could enter the fixture. If a foreign object enters the unit,
immediately disconnect the main power. Also, place the fixture in a well-ventilated
room at about 15 cm from the walls.
•
Do not touch any wires during operation, as high voltage is hazardous.
•
In the event of serious operating problems, stop using the unit immediately. Never
try to repair the unit yourself. Repairs carried out by unqualified personnel can lead
to damage or malfunction. Please contact the nearest authorized Technical
Assistance Center. Always use genuine spare parts.
( 2 ) Preprogram functions
The unit can be linked together as master/slave in daisy chain in linkage as many
units as required and run by built in preprogrammed chase sequences triggered by
music.
Not need to set the dipswitches in master/slave mode.
＊
2-light show
Dipswitch 10 “off” means the unit works normally and “on” means inversion. In order
to creating a great light show, you can set dip switch 10 “on” on any unit that is linking
to the master unit to get contrast movement to each other, even if you have two units
only. Dipswitch 10 on the first unit is no use in the DMX linking, as it is the master
unit that operates the light show.
( 3 ) By easy controller
The easy remote control is used only in master/slave mode. By connecting to the 1/4”
microphone jack of the first unit, you will find that the remote control on the first unit will control
all the other units for Stand by, Strobe/Next and Fast/Slow function.
1.
STAND BY
- To blackout all the units.
2.
FUNCTION -
STROBE/NEXT
-
Under FAST ( LED off )mode, the units will strobe in three
different ways:
a) Strobe in different gobos and colors.
b) Synchronous strobe in white color.
c) Two-light strobe in white color.
- Under SLOW ( LED on ) mode, press FUNCTION button to
choose desired color and gobo. It will change ten colors and then
change one gobo.
3.
MODE -
FAST/SLOW
When the LED is off, it is in FAST mode. The unit’s movement- Pan/Tilt & Gobo/Color is
sound activated. If the LED on, it is in SLOW mode, Pan/Tilt is sound activated but
Gobo/Color wheel are static, controlled by Next button.