Rear View:
Power Switch Turn On/Off the power
Channel Mode Switch Translate between 4 channels mode and 8 channels mode
DC Input DC 9V 300mA min
DMX Output Output DMX signal to the connected fixture
2. Address setting
Each fixture needs to have an address set to receive the data sent by the controller. There are 8
addresses that you can set for LED lightings.
Please follow the instructions below to set the address:
Set LED-RC8 to 4 Ch. or 8 Ch. mode.
Connecting all LED lightings to the LED-RC8 and power them on.
Hold the “black out” button for about 5seconds until the LED blinking.
The first lighting will be on.
Set address for the LED lightings by pressing the chase 1-8 buttons.
Press the “sound to chase” or “ full on” button to select other fixtures,
and addressing for them.
Press the “black out” button for about 5 seconds to quit address setting.
3. How to Connect the unit
Please refer to the following diagram to connect the fixtures:
A. Connect with COLOR BALL/COLOR SPOT
B. Connect with COLOR PAR
Button
address
Chase 1
1
Chase 2
2
Chase 3
3
Chase 4
4
Chase 5
5
Chase 6
6
Chase 7
7
Chase 8
8