In slave mode,
means the unit works normally and
means 2-light show. In order to
create a great light show, you can set
on the second unit to get contrast movement to each
other, even if you have two units only.
4.2 Easy Controller
The easy remote control is used only in master/slave mode. By connecting to
the 1/4” microphone jack of the first unit, you will find that the remote
controller on the first unit will control all the other units in Stand by, and
Mode selection.
Stand By
Blackout the unit
Function
1. Sync. Strobe
2. Async strobe
3. Sound Strobe
Show
1-4
1. Press to select color
2. Hold to select gobo
Mode
Sound
(LED OFF)
Show
(LED Slow Blinking)
LED ON
4.3 DMX Controller
By using a universal DMX controller to control the units, you will need to set DMX address from 1
to 512 so that the units can receive DMX signal.
Press the
MENU
button up to when the
is showing on the display. Pressing
ENTER
button
and the display will blink. Use
DOWN
and
UP
button to change the DMX512 address. Once the
address has been selected, press the
ENTER
button to setup, to go back to the functions without
any change press the
MENU
button again. Hold and press the
MENU
button about one second or
wait for one minute to exit the menu mode. Please refer to the following diagram to address your
DMX512 channel for the first 4 units
：
14
