11A
1.
Connect the fixture together in a “daisy chain” by XLR plug cable from the
output of the fixture to the input of the next fixture. The cable cannot be
branched or split to a “Y” cable. Inadequate or damaged cables, soldered joints
or corroded connectors can easily distort the signal and shut down the system
2.
The DMX output and input connectors are pass-through to maintain the DMX
circuit when one of the units’ power is disconnected.
3.
At last fixture, the DMX cable has to be terminated with a terminator to reduce
signal errors. Solder a 120-ohm 1/4W resistor between pin 2(DMX-) and pin
3(DMX+) into a 3-pin XLR-plug and plug it in the DMX-output of the last
fixture.
4.
Each lighting fixture needs to have an address set to receive the data sent by the
controller. The address number is between 0-511 (usually 0 & 1 are equal to 1).
5.
3 pin XLR connectors are more popular than 5 pins XLR.
3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)
4A
2. Technical Specifications
DMX 1/2/8/9 channels switchable.
Smooth 0~100% dimming and variable strobe speeds.
Two operation modes: DMX, Manual mode.
Ideal for discotheques, clubs, bars, parties, Mobile DJs, etc.
Input Voltage: AC 100V~240V 50/60Hz
Total Power consumption: 800W
Fuse: T10A
LED: 8 x 65W LED
Dimension: 885x 515 x 182 mm
Weight: 16.5Kgs
3. Installation
The unit should be mounted via its screw holes on the bracket. Always ensure