3A
2. Technical Specifications
!
Fitted with 2 x 3W tri-color LEDs, the DMX Fury/Rage LED fills the entire room with
powerful and laser-like muticolor beams, delivering fabulous effects.
!
Great built-in lighting shows under Master/Slave and Sound Active
!
Full range dimmer and variable strobe effects.
!
Optional CA-8 easy controller for enjoying instant lighting shows at you fingertips
!
LED display for easy navigation
!
Idear for discotheques, clubs, bars, parties, Mobile DJs, ect.
!
Input Voltage:
AC100V~240V 50/60Hz
!
Power consumption:
16W
!
Fuse
: T 6.3A
!
LED:
2 x 3W Tri-color LEDs 30000hrs rated
!
Dimension:
296 x 271 x 140mm
!
Weight:
4.0kgs (LED-3082 RGB)
3.8kgs (LED-3084 RGB)
3. Installation
The unit should be mounted via its screw
holes on the bracket. Always ensure that the
unit is firmly fixed to avoid vibration and
slipping while operating. Always ensure that
the structure to which you are attaching the
unit is secure and is able to support a weight
of 10 times of the unit’s weight. Also always
use a safety cable that can hold 12 times of the weight of the unit when installing the fixture.
The equipment must be fixed by professionals. And it must be fixed at a place where is
out of the touch of people and has no one pass by or under it.
12A
8. Troubleshooting
Following are a few common problems that may occur during operation. Here are some
suggestions for easy troubleshooting:
A. The fixture does not work, no light
1. Check the connection of power and main fuse.
2. Measure the mains voltage on the main connector.
B. Not responding to DMX controller
1. DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
2. If the DMX LED is on and no response to the channel, check the address settings and
DMX polarity.
3. If you have intermittent DMX signal problems, check the pins on connectors or on PCB
of the fixture or the previous one.
4. Try to use another DMX controller.
5. Check if the DMX cables run near or run alongside to high voltage cables that may
cause damage or interference to DMX interface circuit.
C. Some fixtures don’t respond to the easy controller
1. You may have a break in the DMX cabling.
2. Check the LED for the response of the master/ slave mode signal.
D. No response to the sound
1. Make sure the fixture does not receive DMX signal.
2. Check microphone to see if it is good by tapping the microphone.
E. One of the channels is not working well
1. The stepper motor might be damaged or the cable connected to the PCB is broken.
2. The motor’s drive IC on the PCB might be out of condition.
