6B
return to the main functions without any change after 10 seconds. Back to the functions
without any change press
MENU
button again.
Fixture Hours
Press the
MENU
button up to when the
is blinking on the display. Pressing
ENTER
button and the display will show the number of working hours of the unit. To go back to the
functions press the
MENU
button again.
Display Inverse
It is good for you to install the unit on the floor or under ceiling. Press the
MENU
button up to
when the
is blinking on the display. Use the
ENTER
button to change to the mode
(display normal), It will automatically store after 8 seconds. Or press the
ENTER
button again return to the mode
(display inversion). To go back to the functions
press the
MENU
button.
Display normal mode for the fixture putting on the floor.
Display inversion mode for the fixture fixing under ceiling.
Software version
Press the
MENU
button up to when the
is blinking on the display. Pressing
ENTER
button and the display will show the version of software of the unit. To go back to the
functions press the
MENU
button again.
4. How to control the fixture
Three ways of operation:
A. Master/Slave operation
B. DMX controller
C. Easy controller CA-8
A. Master/Slave operation
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when you
want an instant show. You have to set the first unit in master mode
. Its DMX input
7B
jack will have nothing plugged into it, and Its master LED will be constantly on and sound
LED will flash to the music. The other units will have to set in slave mode
and select
(normal) or
(2 light show) or
(3 light show) or
(4 light show)
mode, Their DMX cables plugged into the DMX input jacks (daisy chain) and the slave led
lights will constantly on.
2-light show
In
(slave mode),
means the unit works normally and
means
2-light show. In order to create a great light show, you can set
on the second unit to
get contrast movement to each other, even if you have two units only.
B. DMX controller
If you use a universal DMX controller to control the units, you have to set DMX address from
1 to 512 channel so that the units can receive DMX signal.
Press the
MENU
button up to when the
is shown on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the DMX512 address.
Once the address has been selected, press and keep
ENTER
button pressed up to when
the display stops blinking or storing automatically 8 seconds later. To go back to the
functions without any change press the
MENU
button again.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
4 Channels
：
C. Easy Controller (by CA-8)
The easy remote control is used only in master/slave mode. There is a terminator for
connect the easy controller inside the fixture. By connecting the cable into DMX IN
waterproof cable entry gland to the CA-8 terminator of the first fixture, you will find that the
remote control on the first fixture will control all the other fixtures for Stand by, Function and
Mode functions.
