7-
3 Hold
DEL/CLEAR
button, press COLOUR PRESETS 1-8
button, all LED blinking for 3 times, the corresponding LED off
indicating the colour preset deleted succeed.
4 Repeat 2-3 steps to delete more colour presets.
5 Hold PROGRAM/REC button for 3 seconds to exit programming
mode, the LED above PROGRAM/REC button will be off.
4.3 Program Chase
1 Enter programming mode.
2 Press CHASE 1-8 button to choose chase which desired to store
in.
3 Press FIXTURE SELECTOR 1-8 button to choose units, use
UP/DOWN button to choose bank 1-4 that desired to store colour
preset, push fader 1-4 to adjust the light effect, or open a colour
preset stored.
4 Press PROGRAM/REC button, all LEDs blinking for 3 times
indicating one step stored succeed ( it will show “NULL” and do not
store if all outputs are ”0” ).
5 Repeat steps 3-4 to store more steps, each chase 32 steps
maximum, it will show “FULL” when up to 32 steps.
6 Repeat steps 2-5 to store more chases.
7 Hold PROGRAM/REC button for 3 seconds to exit programming
mode, the LED above PROGRAM/REC button will be off.
ATTENTION:
Before using any colour preset or lighting effect, press DEL/CLEAR button
to clean the output you set inadvertently, so that you can avoid storing the lighting effect
that unwished.
4.4 Insert step to Chase
1 Enter programming mode.
2 Press CHASE 1-8 button to choose the chase desired to insert
step.
8-
3 Press INSERT/TAP button, the LED above it will on, the present
step will show on the display (for example, it will show “ST00”
when there is no step).
4 Use UP/DOWN button to select the position of inserted steps ( If
you want to insert fifth step, you should set the present step to be
“ST05”).
5 Press FIXTURE SELECTOR 1-8 button to choose units, use
UP/DOWN button to choose colour preset or push the FADER 1-4
to adjust the lighting effect.
6 Press PROGRAM/REC button, all LEDs blinking for 3 times
indicating insert one step succeed.
7 Repeat steps 3-6 to insert more steps, 32 steps maximum, more
than this it will show “FULL”.
8 Hold PROGRAM/REC button for 3 seconds to exit programming
mode, the LED above ROGRAM/REC button will be off.
4.5 Delete Step From Chase
1 Enter programming mode.
2 Press CHASE 1-8 button, choose the chase whose step desired
to delete.
3 Press INSERT/TAP button, the LED above it will on, the present
step show on the display (it will show “ST00” if none step has been
