ACME HYGIEA, Руководство пользователя

Страница: 30 / 32

4. Try it with another DMX controller.
5. Check whether the DMX cables run near or alongside to the high-voltage cables, which may
damage or interfere with the signal circuit.
C. One of the channels is not working well
1. The stepper motor might be damaged or the cable connected to the PCB might be broken.
2. The motor’s drive IC on the PCB might be out of condition.
D. The lamp is cutting out intermittently
1. The lamp is not working well. Check whether the voltage is too high or too low.
2. The internal temperature may be too high. Replace the cooling fan if necessary.
9. Fixture Cleaning
It is absolutely essential that the fixture is kept clean to ensure the maximum light-output and allow
the fixture to function reliably throughout its life. The fixture must be cleaned regularly to avoid dust,
dirt and smoke-fluid residues building up on or within the fixture. The cleaning frequency depends on
the application environment. Clean the fixture immediately if the dust enters it to avoid damage to
the optical lens due to excessive dust.

A soft lint-free cloth moistened with any good glass cleaning fluid is recommended, under no
circumstances should solvents be used.

Always dry the parts carefully.

Clean the external optical lens at least every 20 days and the internal optical lens every 30 days.
29A