ACME GENESIS MOVE, Руководство пользователя, Страница: 11 / 17

10E
blink. Use
DOWN
and
UP
button to adjust the home position of the Pan, Tilt, color, Gobo1, R-Gobo, Gobo2,
Prism, R-Prism, or Focus. Once the position has been selected, press the
ENTER
button to setup, to go
back to the functions without any change press the
MENU
button again. Hold and press the
MENU
button
about one second or wait for one minute to exit the menu mode.
4. How To Control The Unit
You can operate the unit in three ways:
1. Master/slave built-in preprogram function
2. Easy controller
3. Universal DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address setting will be effect
at once. Every time you turn the unit on, it will show “LED-MS50” on the display and move all the motors to
their ‘home’ position and you may hear some noises for about 20 seconds. After that the unit will be ready
to receive DMX signal or run the built in programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to give an automatic,
sound activated, synchronized light show. This function is good when you want an instant show. You have
to set the first unit in master mode
Show Mode
and select
show 1
or
show 2
or
show 3
or
show 4
mode.
Its DMX input jack will have nothing plugged into it, and Its master LED will be constantly on and sound
LED will flash to the music. The other units will have to set in
slave mode
and select
Slave 1
(normal) or
Slave 2
(2 light show) mode, Their DMX cables plugged into the DMX input jacks (daisy chain) and the
slave led lights will constantly on.
2-light show
In
slave mode
,
Slave 1
means the unit works normally and
Slave 2
means 2-light show. In order to create
a great light show, you can set
Slave 2
on the second unit to get contrast movement to each other, even if
you have two units only.
4.2 Easy Controller
The easy remote control is used only in master/slave mode. By connecting to the 1/4” microphone jack of
the first unit, you will find that the remote controller on the first unit will control all the other units in Stand by,
and Mode selection.
Stand By Blackout the unit
Function 1. Sync. Strobe
2. Async strobe
3. Sound Strobe
Show
1-4
1. Press to select color
2. Hold to select gobo
Mode Sound (LED OFF) Show (LED
Slow Blinking)
LED ON
4.3 DMX Controller
By using a universal DMX controller to control the units, you will need to set DMX address from 1 to 512 so
that the units can receive DMX signal.
Press the
MENU
button up to when the
DMX Address
is showing on the display. Pressing
ENTER
button
and the display will blink. Use
DOWN
and
UP
button to change the DMX512 address. Once the address
has been selected, press the
ENTER
button to setup, to go back to the functions without any change press