V.1.03 www.FlyCamOne.com
Contain in the FCO
Ξ
5.8GHz Transmission Set
•
FCO
Ξ
Sender (TX)
•
FCO
Ξ
Receiver (RX)
•
Manual
Thanks for having bought a FCOIII retransmission set. We wish you a pleasant
use of this item and hope you will delight the several uses that are possible.
Further details are available at our home page:
www.FlyCamOne.com
Settings:
Both Modules do have a dip switch bar for the 8 different transferring channels.
Please make sure both modules do have the same settings you can find on each
module. The use of the camera itself is same as in the past. Nevertheless you
have to exchange the screen from the backside of the camera by the sender.
Once the screen has been removed and once the sender is being fixed, you will
have to take the receiver in order to fix on it the screen.
Now switch on the several modules: Camera, RX and TX. The signal can reach
300 meters when there is no obstacle or interference.
Interferences that could result from the transmission will not be recorded on the
SD card that is directly located in the camera slot.
Audio
In order to transmit the audio signal, you will have to press one time the button
located on the camera. Adjust sound level by turning the audio wheel if
needed.
AV-Out
Use a 3,5mm connector with the short shaft to
plug into unit with AV in. To save energy when
using the AV out, we advise you to remove the
screen that is fixed on the RX module.
FC3013 AV-wire 120cm
3,5mm connector to RCA (red/white/yellow)
How to charge FCO
Ξ
5.8GHz Transmission Set
Once connected to the camera, TX module will start charging. Charging time is
the same as for the camera. Putting the RX and the TX together, will allow you to
charge both units simultaneously.
RX module must be charged with the supplied USB cable.
Charge will be completed once the indicator light will turn from red to green.
