ACME CP-56U, Руководство пользователя, Страница: 7 / 8

9-
own DMX address, not need to calculate the DMX channels of each fixture in the chain.
(Fixture 1 = 1, Fixture 2 = 5, Fixture 3 = 9, Fixture 4 = 13, Fixture…)
3. No need to turn the fixture off when you change the DMX address, as new DMX
address setting will be effect at once. Every time you turn the fixture on, it will be ready
to receive DMX signal or run the built-in programs.
B. Remote DMX address setting by CA-T DMX TESTER
The fixture can be set the DMX address remotely by CA-T DMX TESTER. Please refer to
the CA-T user manual to set the DMX address to the fixture.
5. How to control the fixture
There are three ways to control the fixture
A. Universal DMX controller
B. Master/Slave operation
C. Easy controller (by CA-8)
A. Universal DMX controller
The fixture can be set the DMX address remotely by universal DMX controller. First, you
need to programming two scenes into a chase, and then link the fixtures to the universal
DMX controller. When you run the chase, all the fixtures of the chain will be set the series
DMX address automatically. The fixture uses four channels. Please refer to the following
6-
DMX 512 Address Setting
Press the MENU button up to when the is showing on the display. Pressing ENTER
button and the display will blink. Use DOWN and UP button to change the DMX512 address.
Once the address has been selected, press the ENTER button to setup or automatically
return to the main functions without any change after 8 seconds. To go back to the functions
without any change press the MENU button again.
Auto mode
Press the MENU button up to when the is blinking on the display. Pressing ENTER
button and the DMX address of the fixture can be set automatically by built-in program. To go