Mount the CarCamOne to the sucking pad
Release the four screws of the bottom of the bord cables base. Then release the detached cover panel. The sucking pad contains the suitable
counterpart. Plug the open base on the counterpart of the sucking pad and bolt these parts together. Mount the camera in the same direction as
shown on the picture.
Remove the protective film on the rubber.
Mounting of the sucking pad on the window shield
Clean the window shield with screenwash at the point where you want to fix the sucking pad.
Strongly press the rubber on the window shield and pull the locking lever down. Adjust the camera with the alignment for optimal recording.
Check if the pad is mounted tight enough.
Lever to mount
the sucking pad
Alignment for
fixing the cam
