ACME BW-545, Руководство пользователя

Страница: 14 / 20

4.2 Address Setting
Use universal DMX controller to control the units, you have to set DMX address from 1 to 512
channel so that the units can receive DMX signal.
Press the MENU button up to when the is showing on the display. Press the ENTER
button and the display will blink. Use the UP/DOWN button to change the DMX512 address. Once
the address has been selected, press and keep the ENTER button pressed up to when the display
stops blinking or storing automatically 30 seconds later. To go back to the functions without any
change press the MENU button again.
Please refer to the following diagram to address your DMX512 channel for the first 4 units:
Channel mode
Unit 1
Address
Unit 2
Address
Unit 3
Address
Unit 4
Address
4 Channels 1 5 9 13
5 Channels 1 6 11 16
7 channels 1 8 15 22
4.3 DMX512 Configuration
Please refer to below configurations to control the fixtures
Attentions:
1. The unit will maintain the last condition until reset if you cut-off the DMX signal.
2. For the channel Function, keep the value for about 3 seconds, then the corresponding
function will take into effect.
4 Channels Mode (Mode 1):
Channel Value Function
1
0-255
RED
0%

100%
2
0-255
GREEN
0%

100%
3
0-255
BLUE
0%

100%
4
0-255
WHITE
0%  100%
13F