ACME BW-54-10FC II RL, Руководство пользователя

Страница: 3 / 20

1. Safety Instructions
WARNING

Please keep this User Guide for future consultation. If you sell the unit to another user,
be sure that they also receive this instruction booklet.
Caution
：

All fixtures are intact from the manufacturer, please operate follow up the user manual,
artificial fault are not under guarantee repair.

Unpack and check carefully there is no transportation damage before using the unit.

Do install and operate by operator.

Use safety chain when fixes the unit.

The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces.

Be sure that no ventilation slots are blocked, otherwise the unit will be overheated.

Before operating, ensure that the voltage and frequency of power supply match the
power requirements of the unit.

It’s important to ground the yellow/green conductor to earth in order to avoid electric
shock.

Maximum ambient temperature is Ta: 40
℃
. DO NOT operate it where the temperature
is higher than this.

Don’t connect the device to any dimmer pack.

First run, there will be smoke or smells, and all disappearing a few minutes later.

Make sure there are no flammable materials close to the unit while operating, as it is fire
hazard.

Look over power wires carefully, replace immediately if there is any damage.

Unit surface temperature may reach up to 85
℃ . Don’t touch the housing bare
-hand
during its operation.

Never run on for a long time lest shortening lifespan.

Avoid any inflammable liquids, water or metal objects entering the unit. Once it happen,
cut off the mains power immediately.

Do not operate in dirty and dusty environment, also cleaning fixtures regularly.
Please read the instructions carefully which includes
important information about the installation, operation
and maintenance.
2B