13B
4. How To Control The Unit
You can operate the unit by DMX controller:
No need to turn the unit off when you change the DMX address, as new DMX
address setting will be affected at once. Every time you turn the unit on, it will show
on the display. After that the unit will be ready to receive DMX signal or
run the built in programs.
4.1 DMX Controller
Use universal DMX controller to control the units, you have to set DMX address from
1 to 512 channel so that the units can receive DMX signal.
Press the
MENU
button up to when the
is showing on the display.
Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to
change the DMX512 address. Once the address has been selected, press and keep
ENTER
button pressed up to when the display stops blinking or storing
automatically 8 seconds later. To go back to the functions without any change press
the
MENU
button again.
Please refer to the following diagram to address your DMX512 channel for the first
4 units
：
10B
UP
button to select the
(red),
(green),
(blue),
(yellow),
(purple),
(Cyan),
(white) or
(fade).
Once select
, press the
ENTER
button to setup. press the
ENTER
button
，
will blinking on the display, use
DOWN
and
UP
button adjust the fade time
(0~255), press the
ENTER
button to store and
will blinking on the display,
use the
DOWN
and
UP
button adjust the white time (0~255), press the
ENTER
button
to store or automatically return to the main functions without any change after one
minute. To go back to the previous functions without any change press the
MENU
button.
White Balance
Press the
MENU
button up to when the
is showing on the display. Pressing
the
ENTER
button and the display will blink. Use the
DOWN
and
UP
button to select
the
(red),
(green),
(blue) mode. Once selected, press
the
ENTER
button to setup, then use the
DOWN
and
UP
button to adjust the value
(125~255) or automatically exit menu mode without any change after one minute.
To go back to the functions without any change press the
MENU
button.
Photo Cell Mode
Select the
, press the
ENTER
button and the display will blink. Use the
DOWN
and
UP
button to select the
(Be controlled by sunlight) or
(Not be controlled by
sunlight)
，
Once select, press the
ENTER
button to setup or automatically return to the main
functions without any change after one minute. Back to the previous functions press the
MENU
button.