Aclam Guitars Cinnamon Drive, Руководство пользователя и инструкции по безопасности

Страница: 11 / 13

20 21
Tighten the two thumb screws with your hands or
with a screwdriver.
5
Hook and Loop: Take the included super strong Velcro
®
pad and stick it on the base plate.
Again, make sure the base is clean of dirt and dust.
Pre-drilled pedalboard: Fix it with a bolt and a nut you
could find at any hardware store or instead of passing the
zip tie over the pedal you can take advantage of the Smart
Track enclosure and put the zip ties over the holes.
DIY woodboard: You can screw the pedal directly with
wood bolts through the enclosure side holes.
No board: If you use the pedals standalone make sure
you place the included anti-sliding rubber pad on the
baseplate.
USING OTHER PEDALBOARDS:
Trouble
Shooting
SIGNAL PASSES THROUGH IN BYPASS BUT NOT
WHEN ENGAGED:
Make sure you´ve connected the input and output jacks
correctly.
PEDAL DOES NOT WORK WITH THE POWER SUPPLY:
Take a look at your power supply output voltage and
polarity. Make sure it’s 9V DC negative tip with a minimum
output of 200 mA.
PEDAL WON’T ENGAGE WITH BOTH THE POWER
SUPPLY AND BATTERY:
Check there’s a plug inserted into the Input Jack.
THE LEDS ARE BLINKING:
If you’re powering your Cinnamon Drive with a battery
replace it with a fresh one. See page 9 for more info.
EVEN WITH GAIN AT MINIMUM, THE SOUND
IS DISTORTED:
First of all, check that there aren´t any pedals such as
boosters, preamps or compressors before the Cinnamon
Drive that could increase the volume of your guitar signal.
When you put a Booster before an overdrive pedal and
engage it you increase the amplitude of your guitar signal.
This will hit the saturation section of the overdrive pedal
harder, resulting in more distortion instead of increasing
volume.
The same happens when the output volume is significantly
increased on your Cinnamon Drive; the next pedal in the
chain or your amp might not have enough headroom for
the incoming signal and it’ll clip.
So, in this case check the output volume and reduce if
necessary.