CENTAURI-200 User Guide
VT-ENG-TMP-UG | Rev 1.1 | 31-Jul-19
Volansys-Confidential
Page 13 of 31
4 G
ATEWAY SETUP
4.1 Gateway LED indication
Table 1 Gateway LED indication
4.2 Gateway Switch function
LED
Indication
Represents
POWER LED
ON
Power is available
OFF
No Power supply is connected
LED1
OFF
Access Point mode is off
SOLID RED
Access Point mode is on.
Blinking RED
(1 second off, 1 second on)
End Device Commissioning in
progress
LED2
Green
Internet connectivity available
Red
Internet connectivity NOT available
Switch
Control
Action
SW1
Press the switch thrice where the interval between
two consecutive presses should not exceed 1
second.
OTA Recovery in case of failure in the
application OTA
Press the switch for more than 10 seconds
RF Device Discovery will start to pair end
devices
SW2
Press the switch thrice where the interval between
two consecutive presses should not exceed 1
second.
AP mode of Gateway will be enabled
Long press (Required switch press duration more
than 5sec)
Factory reset the gateway (Clears the
Wi-Fi credentials, remove the paired end
