⑤
“LO CUT” knob
This knob controls the cutoff frequency of the built-in -6 dB/Oct-sloped low cut
�ilter, which is – along with the HI CUT in series - �iltering the output signal of
Delay A before it´s fed back into the input of Delay circuit A (independent
feedback loop for each delay circuit) or Delay B (crossfeedback mode)
dependent from the position of the feedback switch, and also routed to the
⑭
“FLT FB OUT” output jack.
Independent LO CUT and HICUT �ilters are both prepared for Delay A and B.
⑥
“HI CUT” knob
This is a -6 dB / oct high cut �ilter internally routed in series with the LO CUT
�ilter (as described above).
⑦
“CV ZOOM” switch
Select the CV resolution of
①
"RATE CV" knob with this switch. By setting it to
X 10, the resolution becomes ten times �iner.
⑧
“PARALLEL/SERIAL” switch
Switch between parallel mode and serial mode. Select whether to use Delay A
and B separately in parallel mode or continuously in serial mode.
⑨
“FEEDBACK PARALLEL / CROSS” switch
The feedback outputs of Delays A and B can be switched in parallel mode (Delay
A and B have it´s own independent internal feedback path) or cross mode(Delay
A is internally fed back into and B vice versa). (See FIG. 3)
DELAY A
OUT
DELAY B
OUT
DELAY A
OUT
(8-pattern of feedback)
A
→
B & B
→
A
DELAY B
OUT
FEEDBACK
X
PAR
FEEDBACK
X
PAR
FB B
FB B
FB A
FB A
FIG.3
：
Variety of feedback output by switching FEEDBACK
PAR / CROSS switch
7