Acksys AirXroad, Быстрое руководство по установке

Страница: 22 / 40

-
2
-
HARDWARE INSTALLATION
1.
Plug the antennas in

Plug the 2 antennas of your choice (not included) into the Ant.1 and Ant.2
connectors.

For single antenna installation, use Ant.1 connector.

For dual antenna installation, use Ant.1 and Ant.2 connectors.
WARNING: It is recommended to connect a 50 ohms terminator on
unused antenna connector. If not, it may disturb radio link quality and
data throughput, and as well as waterproofness.
2.
Connect the power supply
The device has 2 sources of power supply:

Power through M12 PWR connector

PoE through M12 LAN connector
See the “ specifications” section about the characteristics of the power supply.

The device has no ON/OFF switch. It turns-on automatically when power is
applied. Check LED Power

ON if main power supply or PoE source is ON.

The Diag LED stays red for around 60 seconds, until the device is fully ready
to use. Then the Diag LED turns green.
3.
Connect the Ethernet cable

Plug the Ethernet cable to the device’s LAN M12 connector.

Check that the corresponding LAN LED turns ON at that point.